Hi Everyone
Well, after a couple of months I have managed to change the clutch on my 2007 Seciento 'Van' 1098cc MPI.
Everything is back together but for the life of me get the drive shafts back in. It only goes in as far as the circlips let me. :bang:
Do I need a special technique, or just a big hammer?
The circlips look ok and aren 't obviously damaged.
Any tips that can make this little problem go away so I can finish this job off?
Not looking to bodge it, if possible,
Thanks in advance
Best
Malcolm
Well, after a couple of months I have managed to change the clutch on my 2007 Seciento 'Van' 1098cc MPI.
Everything is back together but for the life of me get the drive shafts back in. It only goes in as far as the circlips let me. :bang:
Do I need a special technique, or just a big hammer?
The circlips look ok and aren 't obviously damaged.
Any tips that can make this little problem go away so I can finish this job off?
Not looking to bodge it, if possible,
Thanks in advance
Best
Malcolm
