HI Guys, I need a bit of help,
I have just purchased a 1988 panda 4x4 for my boyfriends birthday. It is hidden in a garage at my parents house. Unfortunately the gear linkage has popped out.

So I think the part is the welder type gearchange link rods. its the rod at the front of the car on the right side. it looks like a ball joint has popped out. I have managed to squash in back in but it pops straight back out as the bushes are preished. I have purchase a new bush (hopefully the right one) however the part that has the ball end (not the hole end) seem to spin back and forth with ease. I seems like its not attached further up or is that how it is? Im a little lost with this as I do not know what it should be like.

Also I am looking for a rear passenger side light lens and 4x4 rear corner stickers.
Any help would be really appreciated

This one?



Or This part of that?



Or this one



This may help?

https://www.fiatdalys.lt/en/catalog.../0/M6,M7,M8/0/GD/transmission-outer-controls-
https://www.fiatdalys.lt/en/catalog...0/0/M6,M7,M8/0/GD/transmission-outer-controls
Some are pinned and the ball joints need a pair of mole grips to pop them on.

Lenses

http://www.ricambio.co.uk/69-fiat/60-classic-panda-1981-to-2002-/226-lighting

But someone on here normally has one or two parts to hand.

As to the 4x4 badges pinned to the rear wheel arch trim if you find any shout as I need one.

Badges that are very similarly are on sale eBay. Red with a silver surround

https://rover.ebay.com/rover/0/0/0?mpre=https://www.ebay.co.uk/ulk/itm/142087801601

Or is it the large decal that you require.

Greatbushes Ebay. It