BikeDoc

Master is a used Unit. Slave is aftermarket, surprisingly it's a metal Unit, I was expecting Plastic . . .

Neither part includes the Hose . . .

And whilst you're on check the metal water pipe running behind the manifold tends to rust through just where the rubber hose fits on

Leave all the pipe work in place just swap the O rings from teh new pies to the old. But dont drop one like I did. There is no reason...

Cheers guys. I've ordered a secondhand M/C Unit from Club500-Italia, and a new Slave.

It is possible to use the old pipework if its in good condition? If you go the complete replacement route, best overall its very easy to...

Febi is good well respected brand and its not much more than the £60/£80 cheep copies seems like a good idea !

Looks like £80 for a new one, ideally you'd replace the slave too, even if you don't you'll probably have to remove the battery and tray...

Just for a laugh, I checked prices on EuroCarParts, and CarParts4Less . . . around £220, and up to £300+ . . . :eek: Plenty around for...

If you don't replace the slave as well, expect a fight with the so-called quick connector in the pipework between the two. On any car...

Thanks Steve, I was suspecting as much, but it's always worth asking.

Hi dont think that the "clip" is available as a individual part!- an e-bay search for "Fiat 500 clutch pushrod clip!" returned no...

Hi all. Got a message from my Daughter about her 2008 1.2 500 Pop She said the Clutch had 'snapped', bless her, she's no Mechanic! A...

Fiat and alfa only! google multi ecu scan and you will find the web site easy enough! the ELM leads are on e- bay!

In the engine bay look under the scuttle panel !-one either side roughly in line with each end of the rocker cover up high at the back...