Punto (Mk2/2b) LED Wing mirror repeaters

Now that both the mirrors have set, its time to seal the holes up.
For this I decided to use araldite crystal clear adhesive.

Mix it up in the standard 50-50 ratio, then start adding it to each hole.

Dont worry too much about being messy at this point.

When all the holes are filled, go back around with the applicator and mop up any excess, keep cleaning the excess off the applicator or you end up just pushing it from 1 side to the other. Let it dry some more and clean up a bit more.

As it dries, it will sink inwards, so let it completely dry then add another layer to take it up to the correct level. You make need another layer on the deeper holes.