Hi,
Just a quick question i hav three fist size dents in my front drivers side wing. They havnt gone in too much.

Is it possible for me to remove the wing and pop it back into shape or get it panel beat without taking any paint off.

Thanks everyone

hard to tell without looking at it

jip0 said:

hard to tell without looking at it

Click to expand...

To dark to take pics m8 but 2 of them are like flat spots the size of about 2 fingers width and 1 of them is the size of a fist no paint hass been taken off but dents are noticable.

Near the top of the wing where it curves.
At most they have gone in by 1-2mm not that deep

well if you can get the panle of and on easily the might aswell give it a try, unless you go drastic you cant really do to much more damage

jip0 said:

well if you can get the panle of and on easily the might aswell give it a try, unless you go drastic you cant really do to much more damage

Click to expand...

I also heard that you can pop dents out with a puller or something i might try that before removing the wing might work hoping so

Not sure how easy it is to remove the wing

i dont know if them dent pullers are any good i think you have to have the exact type of dent for them to work lool

Can try and push it back out but it rarely comes out perfect and the paint can crack on the joints from going one way then the other. Warm it abit first as the colder the paint the more likely to crack! Good luck

Probaably easier to get another wing. I think they're less that £30 new, so you should get one from a scrappy for less.

Get a paintless dent removal person to look at it.

If there isnt a crease in any of the dents or the paint hasnt already cracked you can usually pull or pop a dent back out without paint damage but there will always be noticeable damage due to the metal stretching! A dent removal bloke will be your best bet!