JNAnderson
New member
- Joined
- Dec 8, 2016
- Messages
- 267
- Points
- 43
Hi All, me again with ANOTHER wee issue.
Driving home this morning (at 60mph, not sure if speed matters at all when it comes to this), I used my screenwash and found that the left side only 'scooshed' out into a wee puddle instead of squirting up the screen. This has happened before and I cleared holes with an earring and all worked well. Tried this again this morning but found that a wee small plastic cylinder shape was pushed out. I pushed this back in, tried screen wash again and this time it shot out and over the windscreen!! Fiddled about again and decided to clear the other nozzle while at it, this caused the working side to come out into a puddle at bottom of screen (these checks were while car was parked). I needed to get to work so drove off and parked in car park and decided to check again. Fiddled a few times again, inside of drivers side got soaked from constantly using washer and still couldn't get them right!!
They're either too high, too low...
Is there an easy way to adjust them? I see the wee plastic cylinder that came out has a wee line marked on it, not sure if this is for adjusting?
Have my MOT on Monday and don't want this to be a fail because of something so small.
Driving home this morning (at 60mph, not sure if speed matters at all when it comes to this), I used my screenwash and found that the left side only 'scooshed' out into a wee puddle instead of squirting up the screen. This has happened before and I cleared holes with an earring and all worked well. Tried this again this morning but found that a wee small plastic cylinder shape was pushed out. I pushed this back in, tried screen wash again and this time it shot out and over the windscreen!! Fiddled about again and decided to clear the other nozzle while at it, this caused the working side to come out into a puddle at bottom of screen (these checks were while car was parked). I needed to get to work so drove off and parked in car park and decided to check again. Fiddled a few times again, inside of drivers side got soaked from constantly using washer and still couldn't get them right!!
They're either too high, too low...
Is there an easy way to adjust them? I see the wee plastic cylinder that came out has a wee line marked on it, not sure if this is for adjusting?
Have my MOT on Monday and don't want this to be a fail because of something so small.