I need to glue a 6mm bolt into a small wooden ball. Any idea what glue would work best to stick these two materials together?
A bit complicated. Need to watch the valve rockers on the top of a Land Rover engine, while turning the engine over, which can only be done from underneath. Got a webcam from Maplin with a tripod mount, but the mount thread is M6 metric instead of 1/4 UNC. Genius! Tripod screw is moulded onto a 12mm ball to pivot. Hobbycraft had a bag of 12mm wooden beads. So a M6 screw with the head cut off, a thread tapped into the centre of the bead, and I've got a swivelling mount that fits and works well. Done the job, worked brilliantly, with laptop under car, but screw not fixed, so need to make permanent.For what purpose? It all depends on what it's for. If it's something... Dodgy... I don't want to know...
Thanks for that, a good shout. I think my araldite may have gone off. Will have to buy some new and mix up the tiniest amount. Another challenge to keep me busy.i think araldite would be best
Done the job, worked brilliantly, with laptop under car, but screw not fixed, so need to make permanent.
Does that pass the "Dodgy" test?
Thanks for that, a good shout. I think my araldite may have gone off. Will have to buy some new and mix up the tiniest amount. Another challenge to keep me busy.
Does that pass the "Dodgy" test?