LuiP
New member
Hi everyone
Yesterday i wanted to install 2 small weel spacers because the alu-weels i got is a little to wide. They touch the inner side of the car (Wheel house)
But when i remove the wheel it self there is 2 small alignments bolts so i can't get the spacers to fit ?
I noticed that the 2 alignments bolts are holding the brake drum together so if i remove them i can take the brake house apart.
Are they needed or can i just remove them ? I saw here at the forum that others said, just remove them. It works without.
Se photo what i mean.
It's a Fiat Punto II 1.2 60 (188) facelift from 2005
As i said i tried to install the spacers yesterday but when i removed the 2 alignments bolts the brake drum could go apart.
Is it safe only with the normally wheel bolts ???
Thank you very much.
BR
Lui
Yesterday i wanted to install 2 small weel spacers because the alu-weels i got is a little to wide. They touch the inner side of the car (Wheel house)
But when i remove the wheel it self there is 2 small alignments bolts so i can't get the spacers to fit ?
I noticed that the 2 alignments bolts are holding the brake drum together so if i remove them i can take the brake house apart.
Are they needed or can i just remove them ? I saw here at the forum that others said, just remove them. It works without.
Se photo what i mean.
It's a Fiat Punto II 1.2 60 (188) facelift from 2005
As i said i tried to install the spacers yesterday but when i removed the 2 alignments bolts the brake drum could go apart.
Is it safe only with the normally wheel bolts ???
Thank you very much.
BR
Lui
Last edited: