I recently bought a punto mk1 td70 , nothing to complain about it mechanically but I need advice on the roof drip side moulding. After i bought it i discovered hidden rust underneath it near the winscreen on one side and the roofrack brackets. I cleaned, sanded and covered with 2 coats of hammerite white (since the car is white). then I covered all with white zinc grease and put on new rubber mouldings but these dont fit snuggly in the area where are the brackets even with doors closed. There is a gap between the roof and the moulding. What do u suggest as a solution for this gap ? And if u can give me suggestions if I did any mistakes in dealing with the problem, maybe I can further touch up or do things differently next Summer.
thanks in advance for any replies !
regards.
Margaux
thanks in advance for any replies !
regards.
Margaux