I've just bought and installed a MM ME111T. 2013 Panda TA 85hp manual.
With the tuning box installed, performance was even worse than without it in Eco mode.
Second start-up and the engine check light came on.
Checked the codes, it was P0068. Cleared it with my Scangauge.
With a Google search, I found this: "The generic trouble code P0068 refers to an engine management problem. A disparity exists between the computer's sensors as to the volume of air entering the intake manifold."
I was able to figure out the me100.com site (boy wasn't that fun) to clear the box and upload new software. I uploaded the 'xxx' software as suggested in the 500 forum recently.
Went for another drive, it was just the same.
According to the translation of the (Italian) instructions, it might be that "Excessive pressure of the turbine. Pressure Sensors maladjusted . Controller ME110T defective."
The solution is:
"Make sure you have inserted the values of change recommended. If the defect persists reduce calibrations with the options change soft."
Has anyone with a MM tuning box had this problem? I'd like to solve it with a software update if possible. The me100.com programme does recognise the box, but clearly it is not working properly.
With the tuning box installed, performance was even worse than without it in Eco mode.
Second start-up and the engine check light came on.
Checked the codes, it was P0068. Cleared it with my Scangauge.
With a Google search, I found this: "The generic trouble code P0068 refers to an engine management problem. A disparity exists between the computer's sensors as to the volume of air entering the intake manifold."
I was able to figure out the me100.com site (boy wasn't that fun) to clear the box and upload new software. I uploaded the 'xxx' software as suggested in the 500 forum recently.
Went for another drive, it was just the same.
According to the translation of the (Italian) instructions, it might be that "Excessive pressure of the turbine. Pressure Sensors maladjusted . Controller ME110T defective."
The solution is:
"Make sure you have inserted the values of change recommended. If the defect persists reduce calibrations with the options change soft."
Has anyone with a MM tuning box had this problem? I'd like to solve it with a software update if possible. The me100.com programme does recognise the box, but clearly it is not working properly.
Last edited: