I have an problem with the clutch operation.
The gearbox was almost impossible to engage yesterday with crunching into reverse. Following the advice here I started to bleed the slave cylinder (metal version), by pressing the clutch, opening the bleed screw until the air stopped coming, tightening and then raising the clutch and repeat until the air stops.
However after getting a few good blasts of air / spray out of the bleed valve nothing is coming out now, and the slave cylinder is not moving at all.
There is plenty of fluid in the reservoir (understand its combined with the brake reservoir)
Clearly I am either not doing this right or there's something else wrong. Can anyone help?
The gearbox was almost impossible to engage yesterday with crunching into reverse. Following the advice here I started to bleed the slave cylinder (metal version), by pressing the clutch, opening the bleed screw until the air stopped coming, tightening and then raising the clutch and repeat until the air stops.
However after getting a few good blasts of air / spray out of the bleed valve nothing is coming out now, and the slave cylinder is not moving at all.
There is plenty of fluid in the reservoir (understand its combined with the brake reservoir)
Clearly I am either not doing this right or there's something else wrong. Can anyone help?