blackscell
Member
I think I'll get it to work. If I clear the error code on PDC it shows the parking sensors and then stops. I'll replace it with a 3 PDC cable loom.I can check it (not today though), but I'm a bit confused. Your problem is the driver airbag (2nd stage), but the value you post in the next picture is of the passenger airbag (2nd stage 3 Ohm).
gr J
Edit: Even if (big if!) the PDC controller is there, it might expect a different sensor (FL vs pre FL).
gr J
You were right about the airbag, I couldn't figure it out. Decided to open the glovebox and see the airbag in there is also with resistors, terrible job from the previous owner and dangerous. Will fix it in a couple of days and hope to get everything working