Basically im in the middle of fitting my cruise control and have come across a few problems!
I've wired the cruise control up correctly as per the guide! And my pedals dont seem to register with the engine node as off when the cruise control is activated - so it dosen't work atm to cut a story short.
What i need to do is earth a wire from the brake pedal switch and one from the clutch switch, these two wires are Normally closed contact (NC) of the switch's and give the engine node the "pedal released" signal.
Basically ive located the switches and the clutch switch has 2 wires a brown/grey and purple/black - ive tested these for current.. so my guess is here the NC wire is the purple/black which dosent seem to have a current and the other dose.
Then onto the brake switch, this has two blue wires - i know i dont need to touch these as they are (+ve feeds)! Then there is a green wire and a white wire, i can only seem to get a very small current off both of these.
Ive tried to look on the maintaince CD but cant make much sence of it... Basically the normally open contact controls the brake lights, etc.. so i wont the oposite wire from the engine node? and the same for the clutch if anybody can help and make more sence of the diagrams etc...
I know rroppe will be able to help me, but i cant get hold of him at the minute and really wana finish it off today
I've wired the cruise control up correctly as per the guide! And my pedals dont seem to register with the engine node as off when the cruise control is activated - so it dosen't work atm to cut a story short.
What i need to do is earth a wire from the brake pedal switch and one from the clutch switch, these two wires are Normally closed contact (NC) of the switch's and give the engine node the "pedal released" signal.
Basically ive located the switches and the clutch switch has 2 wires a brown/grey and purple/black - ive tested these for current.. so my guess is here the NC wire is the purple/black which dosent seem to have a current and the other dose.
Then onto the brake switch, this has two blue wires - i know i dont need to touch these as they are (+ve feeds)! Then there is a green wire and a white wire, i can only seem to get a very small current off both of these.
Ive tried to look on the maintaince CD but cant make much sence of it... Basically the normally open contact controls the brake lights, etc.. so i wont the oposite wire from the engine node? and the same for the clutch if anybody can help and make more sence of the diagrams etc...
I know rroppe will be able to help me, but i cant get hold of him at the minute and really wana finish it off today