dtwelve
Member
do you suffer from the dreaded sticky gear lever can't seem to move it side to side well you need to get your tool box out and grab a 10mm spanner some copper grease and some fine metal sanding paper (emery cloth)
first find the nut on top of the gearbox that attaches the gear selection cables to the box 10mm undo nut watching out for the spring and also the 2 plastic sleeves when undone gently tap the bolt through the rear can let should come with it now the bolt needs to be sanded a little as it's very tight in the sleeves once done grease up then replace all back in remembering to put the plastic sleeves there tighten nut up so it's not too tight as it's a nylon locknut all finished
you might have to do this a couple of times to get it right but no expensive shop fees saying they need to change cables etc
first find the nut on top of the gearbox that attaches the gear selection cables to the box 10mm undo nut watching out for the spring and also the 2 plastic sleeves when undone gently tap the bolt through the rear can let should come with it now the bolt needs to be sanded a little as it's very tight in the sleeves once done grease up then replace all back in remembering to put the plastic sleeves there tighten nut up so it's not too tight as it's a nylon locknut all finished
you might have to do this a couple of times to get it right but no expensive shop fees saying they need to change cables etc