Hello, I was happily driving along then the engine management light came on before completely stopping. The car sat for a couple of hours, restarted ok, the management light went out and drove ok before cutting out again. I got the car home and now am struggling to start at all. With a cheap code reader there were initially faults U1600 and U1602 which I'm not sure are a red herring??
I had no spark and I don't think any fuel getting to the cylinders although I can hear the fuel pump initially running and pressure at the fuel rail.
I was thinking sensor so I have changed the crankshaft sensor after which I now have a code P0335 which I believe is a crankshaft sensor fault however I now have a spark and car tries to go but wont start. I sent the ECU away to be tested and came back ok. I changed coil packs for the hell of it and have a camshaft sensor in the post. The car ran for a while today and sounded fine before failing again... I've visually inspected cables re seated relays fuses etc. The dash now seems to be doing strange things - temp gauge going full scale while trying to start. Anyone got any ideas???:bang:
I had no spark and I don't think any fuel getting to the cylinders although I can hear the fuel pump initially running and pressure at the fuel rail.
I was thinking sensor so I have changed the crankshaft sensor after which I now have a code P0335 which I believe is a crankshaft sensor fault however I now have a spark and car tries to go but wont start. I sent the ECU away to be tested and came back ok. I changed coil packs for the hell of it and have a camshaft sensor in the post. The car ran for a while today and sounded fine before failing again... I've visually inspected cables re seated relays fuses etc. The dash now seems to be doing strange things - temp gauge going full scale while trying to start. Anyone got any ideas???:bang: