Hi,
Multipla 1.9 JTD 2006 - Picked up a new subframe a few years ago and kept it for the inevitable replacement. Would normally do the work myself, but the weather has been less than helpful and I only have an outside space to work.
The guy that did the work has left out the support washer (on both sides) that sits between the top of the front bush and the chassis, either because it had corroded away and he didn't know it was meant to be there, or couldn't be bothered to source a replacement.
The FIAT Part 46465198 is apparently obselete. So my question is - does anyone know the dimensions of the washer please, i.e. OD, ID and thickness please. Also, is it just a plain flat washer, or is it profiled in some way?
Thank you
Multipla 1.9 JTD 2006 - Picked up a new subframe a few years ago and kept it for the inevitable replacement. Would normally do the work myself, but the weather has been less than helpful and I only have an outside space to work.
The guy that did the work has left out the support washer (on both sides) that sits between the top of the front bush and the chassis, either because it had corroded away and he didn't know it was meant to be there, or couldn't be bothered to source a replacement.
The FIAT Part 46465198 is apparently obselete. So my question is - does anyone know the dimensions of the washer please, i.e. OD, ID and thickness please. Also, is it just a plain flat washer, or is it profiled in some way?
Thank you