So it is saying the particulate filter is blocked.Drove less than half a mile MIL back on fan and limp drive this is the only code when i do global read codes
After exhaust manifold , looks something like this, your exact model may be different. As jackwhoo says there is a path to doing this, I know you have renewed the fluid, but you may need more specific information for your model. It should be available to download from the internet.Where is this filter please?
On the earlier photo of the Scan tool it said network unavailable, maybe it was just to far away from it's base internet connection.Sorry I think it means that it doesn't have the software required to connect to the vehicle ecu and carry out the eloys fluid reset/prime
And or the regeneration of dpf after step 1
May be worth a try, although if the Snap On tool has all it's updates, I would have thought it should have worked. Is the service you need in a different area on the Tool, there are often several sections outside of the code reading part, but it could be your model isn't covered. I only use my mates tool so my knowledge is minimal on them.So if i connect to wifi it may proceed?