rolopolo
Established member
- Joined
- Jan 9, 2012
- Messages
- 834
- Points
- 305
Hi,
We’ve just replaced the 330,000 mile DPF,
, for the life of me, I can’t tell the van
(ducato 2.3 180bhp, 2020 euro6d with adblue)
When carrying out MES replace function,
We get a fail out of range, then after about 2 seconds the screen clears.
I’m purely guessing, that it’s something to do with the “generic error” on dpf regeneration status.
As the instructions state it should be status “ok”
Has anyone found a working solution?
Also the same result on a snap on & autel diag system
Multiecuscan ver 5.0 have just updated to 5.1 and will test again tomorrow, but expect the same results as the autel and snap on
Or have Fiat locked this facility out
Cheers Neil
We’ve just replaced the 330,000 mile DPF,
, for the life of me, I can’t tell the van
(ducato 2.3 180bhp, 2020 euro6d with adblue)
When carrying out MES replace function,
We get a fail out of range, then after about 2 seconds the screen clears.
I’m purely guessing, that it’s something to do with the “generic error” on dpf regeneration status.
As the instructions state it should be status “ok”
Has anyone found a working solution?
Also the same result on a snap on & autel diag system
Multiecuscan ver 5.0 have just updated to 5.1 and will test again tomorrow, but expect the same results as the autel and snap on
Or have Fiat locked this facility out
Cheers Neil