Hi all.
so the airbag warning light appeared on the dash out of the blue (just driving down the road) and wont go out.
I'm using MES with ELM v1.4 and have the red/green/yellow adapters for the various CAN modules on the car. The battery in the car was replaced about 3 months ago. Checked all connections under the seats.
The green adapter connects to all modules and when in the airbag module there are 3 faults stored but it wont allow me to clear the faults. They remain there.
The red cable adapter cannot connect to the Airbag module and keeps throwing out a "check cable connection error".
Of course, it reports that the faults remain and need to be fixed before clearing them. However the faults happened about 400km ago and the message in MES shows this. Surely if it was a repetitive/continuous error it would have updated the error with current mileage by now?
The CAN info tab shows the airbag system as recognized and active in MES.
The only other thing is I cannot deactivate the passenger bag. I was trying this to see if I could write something to the airbag module and then try clear the errors.Nothing,nada.
Anyone got any ideas?
Thanks.
so the airbag warning light appeared on the dash out of the blue (just driving down the road) and wont go out.
I'm using MES with ELM v1.4 and have the red/green/yellow adapters for the various CAN modules on the car. The battery in the car was replaced about 3 months ago. Checked all connections under the seats.
The green adapter connects to all modules and when in the airbag module there are 3 faults stored but it wont allow me to clear the faults. They remain there.
The red cable adapter cannot connect to the Airbag module and keeps throwing out a "check cable connection error".
Of course, it reports that the faults remain and need to be fixed before clearing them. However the faults happened about 400km ago and the message in MES shows this. Surely if it was a repetitive/continuous error it would have updated the error with current mileage by now?
The CAN info tab shows the airbag system as recognized and active in MES.
The only other thing is I cannot deactivate the passenger bag. I was trying this to see if I could write something to the airbag module and then try clear the errors.Nothing,nada.
Anyone got any ideas?
Thanks.