G Goodboy Patron member Joined Jul 30, 2013 Messages 15 Points 8 Aug 23, 2013 #1 Hi, can anyone help with the supply of spare parts for Ducato 1991 Hymer gearbox selecter section. Last edited: Aug 23, 2013
T14086 Patron member Written a guide Joined Sep 12, 2004 Messages 39,858 Points 7,250 Location Preston Aug 23, 2013 #2 Are you looking for parts or a diagram of these parts?
OP OP G Goodboy Patron member Joined Jul 30, 2013 Messages 15 Points 8 Aug 26, 2013 #3 Hi, Selector parts are required ideally, however a diagram to help me locating these would be appreciated. Regards,
Hi, Selector parts are required ideally, however a diagram to help me locating these would be appreciated. Regards,
F FreeSpirit Established member Written 5 guides Uploaded 5 resources/downloads Joined Nov 18, 2006 Messages 688 Points 225 Location Sunshine Coast Qld, Aust Aug 26, 2013 #4 Hi Check this great site -Talbot Express Owners Club for info on the Talbot Express & early Ducatos & their siblings. http://www.talbotoc.com/index.php?sid=aad81ca85b5f406578681e108c0e1492 See here for info on the gearbox linkages - http://www.jktowers.fsnet.co.uk/motorhome/TalbotExpressGearbox.htm : and also the home page for above for additional info & parts for the Talbot Express etc - http://www.jktowers.fsnet.co.uk/motorhome/index.htm Hope that helps Cheers
Hi Check this great site -Talbot Express Owners Club for info on the Talbot Express & early Ducatos & their siblings. http://www.talbotoc.com/index.php?sid=aad81ca85b5f406578681e108c0e1492 See here for info on the gearbox linkages - http://www.jktowers.fsnet.co.uk/motorhome/TalbotExpressGearbox.htm : and also the home page for above for additional info & parts for the Talbot Express etc - http://www.jktowers.fsnet.co.uk/motorhome/index.htm Hope that helps Cheers
M maingate New member Joined Dec 8, 2009 Messages 85 Points 14 Location Tyne and Wear Aug 27, 2013 #5 If it is the shift forks that are worn down, they can be built up by any competent welder. They are usually made of brass and can be brazed.
If it is the shift forks that are worn down, they can be built up by any competent welder. They are usually made of brass and can be brazed.