General Internal Diameter of Cinquecento Heater Hose?

Currently reading:
General Internal Diameter of Cinquecento Heater Hose?

Joined
May 9, 2012
Messages
17
Points
6
Hi there,

I'm trying to install a temperature gauge to my cinquecento but I want to attach the sensor to the heater hose instead of the coolant hose. So I'm hoping somebody knows the internal diameter of the heater hose, so I can buy the right adapter.

On another note, does anybody know which way the system flows because I assume it will need fitting at the start to get a true reading.
 
Hi there,

I'm trying to install a temperature gauge to my cinquecento but I want to attach the sensor to the heater hose instead of the coolant hose. So I'm hoping somebody knows the internal diameter of the heater hose, so I can buy the right adapter.

On another note, does anybody know which way the system flows because I assume it will need fitting at the start to get a true reading.

on a 899 there is a hole on top of the cylinder head between head bolts along with on the 1108cc there is a hole for the sender at the back fo the head by the dipstick, so no need to stick it on a coolant pipe


other then that the ID on the hoses are 8mm 15/16mm and 30mm depending on the pipes

Ash
 
whitz My brother is the mechanic fitting this, so my technical knowledge is rather limited but do you mean that it won't matter if it's put on the coolant or heater pipe? My cinquecento is the 0.9 one.

I've got a list of adapters from demon tweaks but I'm not sure if the heater pipe is the 8 15/16 or 30mm.

thanks for the reply!
 
you dont fix to rubber hose,a temp. guage is normally fitted to cyl.head.

 
quiet possible but hoses flex and move and if put on a car with a heater tap may not tell the correct temp if not in flow mode or if water level drops air in heater will not tell you your engine is cooking.:eek:
 
Back
Top