Hello ! I can't find information about pins of the instrument cluster of the Fiat 500 on the forum. I have tried to find information on the Internet, but I haven't found anything. Can you help me ? Thank you.

What are you trying to do?

I would like to launch it and see the backlight.

There is 18-pins connector and I don't know where power supply is.

Wouldn't a multimeter on the car end of the cable tell you which is the live?

Also consider, that the display may have a single power feed and that the control of all lights are can bus controlled? I don't know if that's correct but would drastically reduce the number of wires going to it?

Unfortunatelly, I have an instrumental cluster only.

WladekSupron said:

Unfortunatelly, I have an instrumental cluster only.

Click to expand...

Are you wanting the display to be back lit all the time using the original leds?

If you are wanting the dash illuminating could you not just cover the light sensor so they stay on permanent?

minimadsean said:

If you are wanting the dash illuminating could you not just cover the light sensor so they stay on permanent?

Click to expand...

Don't you need the headlights on to light it up? yes the sensor turns off the dash lighting in bright light.

WladekSupron said:

Unfortunatelly, I have an instrumental cluster only.

Click to expand...

I'm getting confused now. By this, do you mean that you don't have a car and want to use the display in some other setting?

minimadsean said:

If you are wanting the dash illuminating could you not just cover the light sensor so they stay on permanent?

Click to expand...

Hi I'm interested to try this by covering the dash light sensor but where is it? Picture or diagram appreciated.
Regards
Ian

Yes, I would like to check the instrumental cluster. It's spare part for сar that doesn't belong me. I have found information about 18-pin connector. The first pin is GND, the second is +30. The third is +15.

And do you know where are CAN BUS pins on the cluster ? Thx for response.