After over two years off and on. I finally got this x19 widebody done. Full fiberglass body "kit" completely molded in Bumper to fender to rocker to 1/4s to rear bumper. Wheel wells molded in also. Tri-coat and all. I know there some fiat fans on here so i thought i would show you guys.

stunning

oh,just a thought but have you though of spacing the wheels out a bit to bring them out the arches a bit?

nice x19

yes, you should bring out the wheels a bit. it would make it look even better.

since other people are showing off their cars, I might as well show mine.


http://www.cardomain.com/ride/2417376

This is a customers car, sorry to lead you all on. I feel like its my car i have done so muck work to it... I just knew you all would appriecate it. And he put huge spacers on already....

Obviously the wrong wheels then for the job.

The fronts need to be about 8" width while the rears need to be 9" or 10" depending on the offset. I use Compomotive CXRs like these: (they *were* my wheels but my friend Carlo needed them more than me - I'll just have to order a new set when I do need them)