General Undercar neons

Currently reading:
General Undercar neons

Joined
Sep 24, 2004
Messages
3,195
Points
642
Location
Bournemouth
Got myself some red under car neons 2day. Any 1 got any idea where you run the cabling into the car to be able to get it to the dash. Is there an easier way than going into the engine bay and through the same hole as the amp? Also do i just run the wiring through the fusebox (what size fuse) coz the info i got with it is shocking. :eek: P.S. ive got the relay......and everything needed.
 
stupid as it sounds, i'd say run the majority of wires through the back of the car, ie make sure the sides have the wires nearest the back, ive done it running 3 of the wires through the front (sides and front) and 1 through the back, and its very untidy as the wires have to sit in the engine bay, if i was to do it again i'd do it running more through the back and less through the front :)

for the ones that went through the front, i did just use the same hole as the amp/spedo cable (y)
 
Cheers. I have a new hole for the amps behind the dash that i might be able to get wires into without going through the top of the engine bay. Will have a look 2moro. Will also see how i can get the wires through the back as it sounds like a good idea. However i have a feeling the the neons are wired in series. Anyway it'll give me something to test me new ramps on 2moro. Cheers m8. (y) Dan
 
no worries, anything to help someone from making the same mistake i have :eek:

its also easier to route the wires under the car at the back, as at the front if something comes loose the alternator or something can chop up the wire (i've had this too :p)
 
I fitted mine today, i got some max power red ones really good. Think its got about 12 different functions.
 
Back
Top