Styling Tinted side blinkers

Currently reading:
Styling Tinted side blinkers

Joined
Feb 25, 2014
Messages
224
Location
Lydiate
I ordered and received a lovely pair of fiat branded tinted side blinker covers. But when I tried to twist them onto the bulb holders they didn't lock into place like the original clear covers which pinch against the rubber seal ring making them water tight. Only loosely fit, is there an updated or alternate type of bulb holder I could get to fit the covers properly ?
Any advice very welcome I'm gutted I can't fit them correctly ?


Sent from my iPad Air using FIAT Forum
 
Joined
Apr 8, 2008
Messages
16,742
get the tape measure out and see whats physically different between the two

If there is a large difference, send it back to where it came from

Ziggy
 
OP
OP
Confuzzlehogle
Joined
Feb 25, 2014
Messages
224
Location
Lydiate
On the rear part which the bulb pushes into there is a plastic lug on either side similar to a lightbulb bayonet, the inside of the tinted covers are different where these lugs engage?


Sent from my iPad Air using FIAT Forum
 
Top