Technical Throttle body gasket

[Gala]

Hi all,
I have fiat panda 2011 (1.2 69 hp, same engine as in the 500). I want to clean the throttle body and I noticed that there is a gasket on it. I cheaked many websites and I didnt managed to find the right part number...
Someone know what is the right number?
MY vin is: zfa16900004017873

Gal

 

[A3jeroen]

On my 100Hp it's a rubber ring that gets reused.

gr J

 

[Gala]

Some peaple told me the same thing, but I got used to install new gasket after I take out some part.
IF I would not find it, I probably will reuse it

 

[DaveMcT]

Loctite 518 gasket replacement is ideal. It will only cure when air is excluded (within the joint) so no bits of sealant to fall off.

 

[Gala]

So I need to apllay the sealant, let say on the throttle body, and immediately joint them (the throttle body and the engine) together?

 

[koalar]

there's a rubber seal underneath

it doesn't need replacing every time


there shouldn't be any gasket sealant which is likely to cause more problems

 

[DaveMcT]

I use 518 when soft seal gaskets look compressed leave the old seal in place. I agree a new seal is correct but I've never had a problem yet. 518 is not like normal gasket sealant and it only sets where there is no air.
Correct advice it to get a new seal. Getting the job done on a Sunday requires other options.

 

[Gala]

Thank you all for the advice!

 

[Roady27]

Gala, did you have to reset the throttle body when you put it back on?

 

[koalar]

Gala, did you have to reset the throttle body when you put it back on?

the older 1.1 cable and 1.2 electronic don't. Never taken the 69hp one off yet. Cant see why you would unless you are replacing one of the sensors on the side.