General Pre-Cut Window Tinting?

Currently reading:
General Pre-Cut Window Tinting?

Joined
May 31, 2006
Messages
8,586
Points
1,770
Location
Newcastle
This post contains affiliate links which may earn a commission at no additional cost to you.
I tried this and failed it takes hours so instead of riskin it i went to get it done professionaly.
 
if i was u m8y i wood get this!!!

Punto Sunblinds

lastscan.jpg


no mess easy 2 fit!!

Part Number 46002921

if u want 2 see a pic of then i will do 1 4 u m8y

Rob
 
Putting window tints on is not easy mate

If i were you I'd save up and have a pro do it, i've tried twice now and failed misserably

Steve
 
Steve-0 said:
i've tried twice now and failed misserably

haha me too! its bloody tricky.

easier way from back in the day is to take the glass out and spray it with 20% black paint 80% laquer (and then mix that 50/50 with thinner) on the inside of the window (thats the inside, not the outside). that works a treat, and you'd think it would scratch off easily but it doesn't at all. plus tint film peels and bubbles so paint can stay in good condition longer. to do the back window just remove the tailgate and mask off the surrounding bodywork. easy peasy. and if you make a mess of it you only need some thinner to get it off and start again.

if you havent got a compressor and sprayer you could probably use that tint spray stuff in a can instead, but it'll cost way more.
 
Back
Top