Technical Panda 30 engine

[JPSJPS]

Evening all. Just looking for some encouragement and advice. I imported a Mk1 Panda 30 from Italy earlier this year as it was in such good shape in the body. This winter I am embarking upon an engine rebuild for a couple of reasons. Firstly there is some oil leakage from the pushrod tubes, (2 piece efforts) I would not care about this too much but it's a part of the heater and occasionally it fills the interior with oil mist fumes, a shame because the heater is great. Also, the little engine works hard for a living and I want to make the bottom end like new again as I want to do a tour of Europe etc and would rather it didn't start knocking half way over the Alps!

Anyway, It seems these tubes are problematic and it seems like this outfit do a set of special modified single piece tubes for the Panda 30 head. Has anyone tried them I wonder?

Julian

Cover push rod tappet Fiat 500 Fiat 126 Fiat Panda 30 modified set NANNI with silicon rubber rings.

Fiat 500 Sport - Cover push rod tappet Fiat 500 Fiat 126 Fiat Panda 30 modified set NANNI with silicon rubber rings. - Nanni Ricambi Bologna. Ricambi e accessori corsa.

www.fiat500sport.com