Hi guys,
While I wait for my restoration thread to start working, I need som help from you that have a 500 close by. As same of you know, I´m currently rebuilding the front end of my 500F, "Raukstern´s 500F -65 rebuild"
The messurements I need are the ones shown in the pictures below:
1. From the bracket holding the tank to the edge of the floor above the battery.
2. Between the indentations on the "floor"
3. Between the outer side of the inner wheelhousings and between the whwwlhousing along the "floor" och the trunk/boot.
If I could get it in millimeters it would be lovely. Otherwise I´ll find some way to translate it.
This is all ti help me get the boot floor positioned right.
Thanks /Seb
While I wait for my restoration thread to start working, I need som help from you that have a 500 close by. As same of you know, I´m currently rebuilding the front end of my 500F, "Raukstern´s 500F -65 rebuild"
The messurements I need are the ones shown in the pictures below:
1. From the bracket holding the tank to the edge of the floor above the battery.
2. Between the indentations on the "floor"
3. Between the outer side of the inner wheelhousings and between the whwwlhousing along the "floor" och the trunk/boot.
If I could get it in millimeters it would be lovely. Otherwise I´ll find some way to translate it.
This is all ti help me get the boot floor positioned right.
Thanks /Seb