help needed fitting double din unit

Currently reading:
help needed fitting double din unit

Joined
Oct 9, 2008
Messages
181
Points
65
Location
blackpool, lancashire
currently installing a beat 600 double din unit but i am having problems powering it on, there are no fused blown and i have been to the local ice garage and he said because of something to do with the connect nav, i need to connect the yellow power cable to the red ignition cable, so i hav cut into the red attached the yellow so that the yellow cable joins to red (which i think was what he sed to do :confused:, need to write things down) and connected it all up but still does not work? anyone installed one before or no where i am going wrong or what i should do?!?!?!
need sum help before i get too annoyed!

cheers chris
 
Hi Chris the Wiring Harness should already have 2 connectors for the red wire so all you need to do is disconnect the yellow (should be on bullet connectors) and connect it to the red. If that hasnt worked then double check all of the fuses. Dont forget that you have to manually power up the HU.
 
unfortunatly the the beat does not have bullet connectors but in line fuses
check the power ncoming up to the power suppy iso block make sure it has power
also make sure the pin is in the same place both sides of the iso

p.s what car is it going into as this will help us help you (y)
 
Back
Top