General Front anti roll bar d bush

[raineuk]

Could some explain why these are so bloody expensive. C'mon £34 plus delivery for a couple of rubber d rings.

 

[bikes-for-me]

Could some explain why these are so bloody expensive. C'mon £34 plus delivery for a couple of rubber d rings.

Think i paid £22 for mine off ebay,but he wonted £6 postage which was a joke.Still a lot cheaper then buying the whole thing.

 

[JTDman]

If you can get the measurements for them give either powerflex or superflex a ring and buy some nylon bushes you will never need to do them again, plus they will be better and prob cheaper.

 

[SGThirkell]

If you can get the measurements for them give either powerflex or superflex a ring and buy some nylon bushes you will never need to do them again, plus they will be better and prob cheaper.

Yeah I had same thought. I emailed them a month or so back and they said if I sent a diagram and dimensions, they'd match it with their better quality bushes.
Asked on a thread if anyone knew the dimensions etc but no replies
I've not had any time to look into it fully myself and was hoping someone who'd took theirs out could help.

 

[Oletimer]

According to one of our breathren the dimensions are:​

30mm high x 50mm long x 38mm deep 18mm hole and a 4mm retaining lip for the top half of the clamp.​

Can't draw on here, hope this helps.
There is a good picture on this in an earlier thread.
George​

 

[SGThirkell]

According to one of our breathren the dimensions are:​

30mm high x 50mm long x 38mm deep 18mm hole and a 4mm retaining lip for the top half of the clamp.​

Can't draw on here, hope this helps.
There is a good picture on this in an earlier thread.
George​

How about this...............

 

[nelsonrocha]

How about this...............

I've found the same ones at silentblocks.com

 

[NumanR]

Desira Group will have in stock next week, original type ARB bushes for £9.50 each plus vat. The part number is P26349

Desira Group can be contacted on 0845 3460701 or www.desiragroup.com

They also have repair kits available for the trailing arm bushes part number
P40025

 

[nelsonrocha]

Could some explain why these are so bloody expensive. C'mon £34 plus delivery for a couple of rubber d rings.

Buy them from silentblocks.com, this site can give you a discount if you tell them you're from England.

 

[Peat]

Having done it myself, I would recommend getting the SAAB 9000 bushes (SPF1816/18) from SUPERflex and cut them to size using a template from the old bush allowing an extra 1-2 mm overall. Checking them against the brackets as you cut away surplus material. I used a Stanley knife but I'm sure there must be a better and easier method!

Once fitted, by splitting the bracket in situ, they improve the front end stability allow greater cornering speeds, and are not likely to wear out again.

Well worth the hour or so carving them to size and the cost (£21 and change posted from memory).You pays yer money and takes yer choice!

Best of luck

Peat