EnlighterFI
New member
- Joined
- Aug 2, 2015
- Messages
- 1
- Points
- 1
Hi!
Sorry for my bad english
Can someone help me!
I am trying to add led-light to rear inrerior (rear courtesy) to an existing light. It should operate when the side door is opened (like the original is acting)
Interior light has 3-pin connector. I think that one is ground.
Only problem is that for some reason i cant figure out which wires needs to be joint with this ne ledlight. Its either burning constantly or like dimmed.
How does the door pilar switch operate? It has two wires. Does it ground the circuit or is that some kind of switch that gives signal to some where else to power up the interior light?
Can someone give me answer what i neen to do to add leds to existing circuit with the original light.
Sorry for my bad english
Can someone help me!I am trying to add led-light to rear inrerior (rear courtesy) to an existing light. It should operate when the side door is opened (like the original is acting)
Interior light has 3-pin connector. I think that one is ground.
Only problem is that for some reason i cant figure out which wires needs to be joint with this ne ledlight. Its either burning constantly or like dimmed.
How does the door pilar switch operate? It has two wires. Does it ground the circuit or is that some kind of switch that gives signal to some where else to power up the interior light?
Can someone give me answer what i neen to do to add leds to existing circuit with the original light.