Technical Fiat doblo 2007 1.9multijet and cruise stalk

Currently reading:
Technical Fiat doblo 2007 1.9multijet and cruise stalk

Phosaly

New member
Joined
May 21, 2017
Messages
7
Points
2
Hi

Alfa stalk 147
Pin 1 = Green = Resume
Pin 2 = Blue = +12V feed
Pin 3 = Not Connected
Pin 4 = Violet = ON/OFF Switch
Pin 5 = Orange/Black = Speed +ve
Pin 6 = Orange/White = Speed -ve

ESI Bosch 2013 the Wiring Diagram Schematics And Diagrams
А38=Pin 1 = Green = Resume
Pin 2 = Blue = +12V feed
Pin 3 = Not Connected
А77=Pin 4 = Violet = ON/OFF Switch
А78=Pin 5 = Orange/Black = Speed +ve
А56=Pin 6 = Orange/White = Speed -ve

My ecu edc16cf4
Please help me why my cruise control don't work
e179cf6s_1920.jpg


BOSCH_EDC16_UC40.jpg
 
Have you just fitted the stalk?
If so you need to enable cruise control in the ECU configuration. You can do this with Multiecuscan (registered version) www.multiecuscan.net ASSUMING the firmware in you ECU supports it. Years ago I tried this with a Marea and while I could see all the inputs from the stalk via the OBD port It would not enable. Cruise was not an option from the factory on my Marea. If it was a factory option on your Doblo when new, there is a good chance it will work.

Robert G8RPI.
 
Sorry
Checked and it don't a factory option on my doblo
Yes used Fiatscan and tried activate cruise but don't have these option in the my ecu
 
Need electric wiring diagram for ecu edc16cf4
 
Last edited:
Hello!!! In Doblo it's disabled in ECU. I've changed cruise_enable bit in ECU, but Multiecuscan shows "cruise generic error"
 
Hello!!! In Doblo it's disabled in ECU. I've changed cruise_enable bit in ECU, but Multiecuscan shows "cruise generic error"

Phosaly might have seen further progress

My experirnces are that MOST of the FIAT ECU dont support cruise.. but its possible to add the necessary kit to make aftermarket CRUISE work

A company in the UK midlands advertises a @£350 fitted system..

Do you have a clutch switch as standard?
 
Back
Top