Clifford CanBus Alarm - Valet Mode

[joeraz]

I received the car yesterday after the alarm installation, told about the Valet mode but they had no clue what the 4-digit code was to disarm it if i lost my fob or broke it. Any1 know if theres a factory preset on this clifford as the garage had no clue, which was strange. I know how its done using the valet button but need a code.

Alarm works well other than the 6 flash code i get at every arming plus the extra chirp,, hmmm

 

[beany_bot]

dont know about this alarm dude but if you paid for a service and they installed the alarm they should give you this "code" or whatever it is!

 

[joeraz]

I know, they are approved installers too, waiting on them mailing me back,, they insisted i needed no 4-digit code but i read the manual (< quite unusual) and it states it there.

 

[StevenRB45]

How odd my alarm has the code on a sticker on the front cover of the manual.

 

[joeraz]

How odd my alarm has the code on a sticker on the front cover of the manual.

I found out today that the installers do not have the machine needed to input a personal code, its the factory single push thats pre set just now.

 

[paulbfd]

The 4 digit code is so you can override the alarm if you lose the fob isn't it? You should a button (well, it's actually 2) somewhere that you use to turn the alarm off.

If they are "approved" then they obviously shouldn't be if they can't help straight away.

 

[MR_TOAD_INSTALLER]

They should not fit alarms they do not have access to via Clifford programmer That me that is running b4 you can walk

any problems they cannot access as no programmer or no software beware

Ian