General Multiecuscan problem connection

Currently reading:
General Multiecuscan problem connection

Joined
Dec 4, 2008
Messages
19
Points
7
Location
Bucharest
Hi! Please a little help.

I do not know where I'm wrong but fail to connect with ELM 327 interface to my Fiat Stilo body, service, other, etc..., only on ENGINE.

I did all the tests, I installed and configured USB drivers Multiecuscan changed here and there one another but with the same results.

If I give in Multiecuscan to scan, it find only engine like the picture below and during the scan my message board loose coonection appears two or three times:

See the image scan below.

USB port settings are shown in the image below if I change something it does not connect nor ENGINE:

See the image usb below.

If I give the test it displays the following results:

COMMAND: ATZ
RESPONSE: ATZ
ELM327 v1.5 >

COMMAND: ATI
RESPONSE: ATI
ELM327 v1.5 >

COMMAND: ATE0
RESPONSE: ATE0
OK >

COMMAND: ATL0
RESPONSE: OK >

COMMAND: ATH0
RESPONSE: OK >

COMMAND: ATSPC
RESPONSE: OK >

COMMAND: ATS0
RESPONSE: OK >

COMMAND: ATCAF0
RESPONSE: OK >

COMMAND: ATCFC0
RESPONSE: OK >

COMMAND: ATCRA 7B0
RESPONSE: OK >

COMMAND: ATSH 7B0
RESPONSE: OK >

COMMAND: ATAT1
RESPONSE: OK >

COMMAND: ATST41
RESPONSE: OK >

COMMAND: ATBI
RESPONSE: OK >

This interface is compatible with ELM 327 1.4! Should connect properly with all CAN modules.


It may be a problem with the software Multiecuscan? I tried versions 1.7 and 1.5 with the same results. Mention that if I give it ok to settings the following message appears:


See the image error below.


Thanks in advance!


P.S. Sorry to admin if there is another topic like this.
 

Attachments

  • scan.jpg
    scan.jpg
    150.1 KB · Views: 797
  • error.jpg
    error.jpg
    168.7 KB · Views: 498
  • usb.jpg
    usb.jpg
    159.9 KB · Views: 463
Last edited:
Back
Top