Help with some wiring a alarm to punto.

Currently reading:
Help with some wiring a alarm to punto.

Joined
Apr 11, 2005
Messages
504
Points
202
I got a cobra 3193 alarm to install into a 55sx.
Theres a few things i didnt really understand on the instructions (image posted)

The 1st is the one were it goes into the steering coloumn, is that ACC or Imbolizer? If either what colour is the wire, in the haynes max power manual it says brown, over at PSC forum someone said orange.

The next is engine cut off? What color are them wires.

the last one speedometer sensor. (automatic door lock after set time or speed) in the manual it says,

Vehicle Speed Sensor (VSS)
The VSS is a signal which frequency is proportional to the speed of the vehicle (normally is a sqaure signal f max = 4KHz).
If the activated function requires it, the VSS signal must be connected to the PINK/BLACK wire of the alarm.
In some vechiles this signal must be taken directly on the tachymeter. The signal should not be taken on ABS control system or on control circuits to prevent any vechile malfunctions.

Do i connect that Pink/Black wire to the blue wire from the rev counter?

There also isnt anything in the manual to set what revs the doors will lock.

Thanks for your help.
Dom

Problems are indicated in red
http://i38.photobucket.com/albums/e125/y2dom/LastScan02.jpg
 
Back
Top