Technical Clutch and flywheel replacement probs

Currently reading:
Technical Clutch and flywheel replacement probs

cammy72

New member
Joined
Jul 21, 2011
Messages
12
Points
4
tw200 had its 2nd clutch and flywheel at a local garage today , car was running when it went in , after having the clutch and flywheel replaced the garage cant get the car to start , its turning over but wont start
any ideas guys , help much appreciated
thanks
Andy
 
Crank shaft sensor needs replaced. Seen it before. Very common after flywheel replacement.
 
thanks for the reply , how sure are you mate , car was running when it went into the garage now after the replacement clutch and flywheel its wont start. garage has a hand held computer that doesn't show any fault codes
thanks for the reply and help
Andy
 
97% SURE, The code wont regester unless the engine starts. If the sensor is not working the ecu does not allow the engine to start. Like I said earlier I have seen this before on these vehicles on a few occations. Good luck, Please keep us informed.
 
was a connection that had been disconnected by accident behind the airbox , all good at the minute , time will tell though lol
dont expect much after only getting 25k to 30k from the last clutch and flywheel
 
ohh thanks for the help btw mate , much appreciated
Andy
 
what did it feel like before it went im suspect of my own and want to catch it in time regards
have you had any other probs you had with your van?
 
well thats another clutch and flywheel fitted in the scudo last week , 3 in a year , cant believe fiat can get away with these parts

@scudo31 , yes mate plenty more problems with with this scudo , anti-roll bars every other month
 
a good cheap and cheerful fix to the antiroll bar (well its fine for 25k km so far so good) is to take it out open the steel strap around the bush grind or file the dowel so it closes back again split the bush and use a piece of 1" copper approx 1" lenght split with a hacksaw and use as a bush inside the old bush tighten back up again and jobs a good one 3 hr job jack two stands vice few tools
handy if your outta warranty
 
Back
Top