General Scudo Number Plate Bulb

Currently reading:
General Scudo Number Plate Bulb

Aich

New member
Joined
Feb 1, 2009
Messages
4
Points
1
Hi there,
Can anyone tell me how to change the Number Plate Bulb on a 2003 Scudo, before I get pulled over by the Boys in Blue.

Thanks,
Aich
 
take the two screws out and remove it, from memory you need to push it to one side to release it. Split the lamp holder and the housing and then you can access the bulb. If you can't get it let me know and I will remove mine again tonight and let you know exactly how it comes out after removing the screws.

Hope this helps.
 
hi if it is the same as my 2004 was ,it has no screws at all :bang: i removed the rear door panel to find out all you do is push the holder to one side and pull it out ,at first you think you are going to break it but it does come out ,a complete nightmare design ,once its out you wont have a problem again getting it out because once its been removed the damn thing will keep falling out (n)(n)
 
Hi LNZ,
Thanks for your interest. Unfortunately, my van is different and the bulb fittings have no screws to remove.
Regards,
Aich.
 
Hi Baloo,
Thanks for your help.
Having already removed the Ply Lining and inner panel, yes you are quite right the whole fitting does slide to one side and I did'nt have the sphericals to go that extra mile and yank it out. I really did think it would break.
Having read your post, I will have another go and try that little bit harder.
Regards,
Aich
 
Well I've finally got around to trying the number plate light holder again and yes I did get it out as described by baloo. So far it hasn't fell out again, it's been 4 days and going strong.

Thanks for the advice.

Regards,

Aich.:D
 
Back
Top