Mr FIAT - Your #1 source for vintage car parts

Technical 284mm front brakes

Currently reading:
Technical 284mm front brakes

G

Greg123

Member
Joined
Nov 29, 2011
Messages
133
Points
99
Location
Nottingham
I see the later 95hp is listed as 284mm front brakes, can anyone confirm if that is always the case in the uk.

I have I presume a 256mm setup on a 2012 1.3 duologic, can anyone confirm if it's just the discs and caliper carriers that are different, or if it's different calipers and pads as well?

As they are to be painted to show standard before fitting, I may as well get an upgraded setup and prepare it then swap them.
 
The calliper bracket are different width, I am sure the calliper are the same but the pads it will be different width but not the height. My old Punto 1.9 HGT is 284mm over the standard Punto is 256mm I know the bracket are different size, the calliper are same but the disc and pads are different. Look on Grande Punto 1.3 90 have 284mm disc are same brake system on your Qubo worth take two brackets off from Grande Punto at the scrapyard and try it but it is at your own risk. I am 50/50 sure it will work. But remember your alloy/steel wheel mind be too small for 284mm disc? the Punto HGT was 15inch alloy.
 
Last edited:
I should be able to report back and tell y'all shortly as I have bought a punto tjet 284mm setup ordered and I will mock it up soon as it arrives. Looks like I will need the discs from the punto as qubo 184mm discs seem to be 98mm pcd wheel bolt holes, later quob mush have switched from the gm 4x100 back to the traditional fiat 4x98 pcd.

Theflyingpostman said:
The calliper bracket are different width, I am sure the calliper are the same but the pads it will be different width but not the height. My old Punto 1.9 HGT is 284mm over the standard Punto is 256mm I know the bracket are different size, the calliper are same but the disc and pads are different. Look on Grande Punto 1.3 90 have 284mm disc are same brake system on your Qubo worth take two brackets off from Grande Punto at the scrapyard and try it but it is at your own risk. I am 50/50 sure it will work. But remember your alloy/steel wheel mind be too small for 284mm disc? the Punto HGT was 15inch alloy.
Click to expand...
 
You must log in or register to reply here.

Similar threads

Molyx
  • Question
Technical QUBO Brake Pressure Sensor
Replies
0
Views
336
Molyx
Molyx
Cadmier
General Is it possible to turn off all front passenger side airbag warnings?
Replies
6
Views
520
portland_bill
portland_bill
M
Technical rear brake adjustment
Replies
6
Views
2K
MTD
M
T
Technical Clunking from o/s front coil spring when turning steering
2 3
Replies
40
Views
11K
Besa
B
P
General Qubos and the folding front passenger seat
Replies
8
Views
4K
Professor Peach
P
Back
Top