Technical fly by wire problem

Currently reading:
Technical fly by wire problem

If it's a fly by wire system you would have a device to send the wanted throttle value from the pedal area, the ECU tells the engine throttle what value to be at and a sensor on the throttle body to feedback what its at.

So you should have 2 things to check, starting around the peddle area, I havent a clue where to start, mine is a direct cable being a mk1
 
Hi Dave, your car has a throttle learn facility which is used to learn the correct positioning of the throttle butterfly. For this you have to switch on and leave the accelerator for a minute and then start up. I have had a few ecus which have repeatedly lost this setting, 1 ecu had to be replaced for this problem as it became so regular. I take it you have a fault code reader which you have tried to get a code from the ecu?
 
it's aliveeee. disconnected + pole wire on the battery for few minutes
 
Last edited:
is this my pedal, what bit do i need to buy :confused:

untitled.jpg
 
Give me a ring during the week mate to organise it I will pm you my phone number, we can sort your loom out as well.
 
Back
Top