I got a mk1 1.2 60S and I can see a slight oil leak from the cam seal (timing belt end). The seal is cheap enough but is it a big job to fit? Was thinking as I got the cambelt off may aswell replace it. It all looks pretty straight foward but any advice would be a good help.
Technical Cam shaft seal
- Thread starter ger
- Start date
Currently reading:
Technical Cam shaft seal
just remove vernier pulley pick the old one out and push the new one in simple
if you remove the bearing cap to do the job you will need some zero gap sealer to reseal the thing or you will cause another leak
if you remove the bearing cap to do the job you will need some zero gap sealer to reseal the thing or you will cause another leak
Do you mean the rocker cover seal| Undo the 4 bolts on the rocker cover, remove the old one and clean everything.. then fit a new one, using a bit of blue gasket sealer for good measure.
Ralf S.
Ralf S.