Technical Aftermarket Radio help needed

Currently reading:
Technical Aftermarket Radio help needed

Joined
May 26, 2015
Messages
32
Points
10
Hi,

So I have an aftermarket radio:http://www.caraudiodirect.co.uk/alpine-ute-72bt-media-receiver

And I bought this fascia plate and harness:http://www.ebay.co.uk/itm/400781754993?_trksid=p2057872.m2749.l2649&ssPageName=STRK:MEBIDX:IT

I have all the wires in place to my sub and kenwood 6x9's in the back, I just need help with how to wire in the radio!

Apparently my car is can-bus so I need to wire the red wire to the ignition live? If anyone has done this before I would really appreciate some help!!!! :worship:

I will add some pictures shortly!
 
This post contains affiliate links which may earn a commission at no additional cost to you.
Hi,

So I have an aftermarket radio:http://www.caraudiodirect.co.uk/alpine-ute-72bt-media-receiver

And I bought this fascia plate and harness:http://www.ebay.co.uk/itm/400781754993?_trksid=p2057872.m2749.l2649&ssPageName=STRK:MEBIDX:IT

I have all the wires in place to my sub and kenwood 6x9's in the back, I just need help with how to wire in the radio!

Apparently my car is can-bus so I need to wire the red wire to the ignition live? If anyone has done this before I would really appreciate some help!!!! :worship:

I will add some pictures shortly!

SEARCH the GP section ,as the story will have been told before, ;)
Charlie
 
This post contains affiliate links which may earn a commission at no additional cost to you.
I have just done this on my 2013 punto and I run an ignition live wire from the cig lighter, on my one it was the centre wire on the cig lighter plug, but check to be on the safe side
 
I had to take my car to a car shop to install it, it had to be repinned and and axtra wire had to be pulled :s 30€ for the instal ... good luck with yours! its very hard to change anything on the punto's hifi system :s
 
Back
Top