Hi,

Has anyone replaced the twinair drive belt please?

Not sure of the belt rout and how to release the tensioner.

Also I maybe replacing the tensioner. Would anyone know the torque setting to mount the new tensioner please?

Amy tips will be greatly received.

Many thanks.

rallycinq may have done this..

How many miles on belt..??
Check other bearings.

Charlie

Never mind... Some pics

Remove cover 2 10mm nuts 1 10mm boot (across flats)

No way was the existing tensioner locking back up, so fitted the one I got just in case.

1 13mm bolt holds it in and it slots into groves I think. Seem to remember messing up the panda mj one.

Don't remove the L shaped pin from new tensioner until it's fitted and the is belt ready and checked. Again something that I learned the hard way on the mj panda.

Don't know torque settings for belt tensioner bolt... Usual ta info blackout?

Saved a few £££

What mileage did it fail at?

Obvious delamination.. just age..??