Tizzywizzy1uk
New member
- Joined
- Sep 10, 2017
- Messages
- 43
- Points
- 10
hi all. i have a panda 56 plate and have been having issues with abs.
the front sensors were replaced with new, then i found out about testing ohms, and the rear wasn't reading anything so i replaced these and still have the abs light on.
when testing the sensors the rear are 492 and 452 and the front are 452 and 352 ohms.
would these reading be normal? the 352 is the drivers side.
iv'e run out of ideas with this and would appreciate any help.
i replaced the faulty gearbox with one from a 52 plate punto about 3 months ago but i cant remember when this abs light came on.
the front sensors were replaced with new, then i found out about testing ohms, and the rear wasn't reading anything so i replaced these and still have the abs light on.
when testing the sensors the rear are 492 and 452 and the front are 452 and 352 ohms.
would these reading be normal? the 352 is the drivers side.
iv'e run out of ideas with this and would appreciate any help.
i replaced the faulty gearbox with one from a 52 plate punto about 3 months ago but i cant remember when this abs light came on.