hi i know there are probably 1000 threads about suspension, unless ive missed it i cant seem to find an answer to my question...

which is will the springs of a fiat 500 abarth fit onto my panda? im under the impression they will lower the car a little bit more and have sourced a set but obviously have no answer.

thanks in advance

a bit late i know, but I'm new to this, yes the rear units fit, and the front ones need a small about of manipulation on a hose bracket and only lower the car around 2cm

The 1200 500 rear springs are quite a bit softer than Panda 169 rear springs. They improve the ride but cause it to sit too low especially with a full car. It can end up looking tipped up at the front.

The Abarth 500 should have harder spring rates but then the 100HP should also be harder than more basic Pandas.