Hi there,

Finding it bloody hard to get the coolant out to replace, turned the tap by the top of the radiator and then tried to get the clip off near the tank but it won't budge.

How is it done? Can't find proper help online.

Panda 1.2 Dynamic 2007.

Any advice?

Thanks

mash off bottom rad hose clip, drain. use a new screw clip to refit

Was trying to avoid that but it seems like the only way now. Thanks mate

dave said:

mash off bottom rad hose clip, drain. use a new screw clip to refit

Click to expand...

It's got a quick release coupling on both rad connectors so you don't have to remove the clip

Just press the 2 tab in that sit each side of the connector and then yank / wiggle away from the rad - bottom hose as mentioned above

Broke it off...Temporary plastic wire tidy is in place currently.

Thanks for the help

there is extremely high pressure in cooling system, don't drive it with a cable tie on it

dave said:

there is extremely high pressure in cooling system, don't drive it with a cable tie on it

Click to expand...

:yeahthat:

What did you break

Damn need to get a jubilee clip asap! The cable tie is around the pipe below the coolant reservoir tank.

Thanks