I have a 2018 4x4 TA, and have looked at the Wooly Pandas post about horns
I also have a Denali Sound Bomb Horn taken from one of my BMW airhead bikes. It has a strong sound which really wakes the dozing driver/pedestrian and I would like to put it on the Panda.
The bike it was on (not can bus) required no mods to the wiring, and the Denali just connected to the two horn wires. I think however the standard bike wiring had a relay for the original horn..
Can I put the Denali straight on the Panda without causing any electrical/electronic problems with the can bus, or any other electrics/electronics
Does the standard Panda horn operate via a relay?
I have little difficulty with the wiring of 1930's 40's 50's 60's even some 80's bikes, but the Panda is light years away from them!
Expert advice please, thanks in advance

If the Panda horn is a single wire id assume its still a good old fashioned type. I'm also sure there is an under bonnet relay.
Personally I'd fit a Klaxon to wake up those dozy folk!!!

Hi Trevor
Believe me the Sound Bomb is LOUD
I'll look for the underbonnet relay Thanks