Technical Rubber bumper part number
- Thread starter khbk
- Start date
Currently reading:
Technical Rubber bumper part number
My Panda 4x4 doesn’t appear to have any little rubber ‘bumpers’ on the door sills? Not sure the previous one did either? But there is a raised metal circle where they might be expected to go...
The Panda Nut
Nutty about Pandas Infected by Panda virus and OPD
My two don't have sill stops either. Just roof level stops on the front doors. I am not sure why they might be needed.
I fitted D section 3m rubber round the rear doors on my Bravo. It stopped dirt ingress onto the door jambs and sills and reduced wind noise. The doors also made a nice sound when closing, Am considering this on the Pandas.
Last edited:
Are we talking about this rubber buffer? Only at top of front doors. There are two places lower down where another might go, and similar point in rear door frame. So far as I can remember, neither of my previous Pandas had these either, so likely ’not needed’?
Edit:
Posted same photo twice and can’t edit from phone - two places on front door frame: one by the latch (as with the rear door, pictured) and one at the bottom.
Edit:
Posted same photo twice and can’t edit from phone - two places on front door frame: one by the latch (as with the rear door, pictured) and one at the bottom.
Attachments
Last edited:
I believe that is the correct part number - but, as I've replied above, can't see why they are there, and on my car, they are only fitted at the top of the front doors.
The Panda Nut
Nutty about Pandas Infected by Panda virus and OPD
Well that's what I was. Both my Pandas are the same as your photos.
