I've found that the two rear seat seatbelt locks have been worn from rubbing together substantially in the short life of my Panda, so I came up with a solution. I'm not sure how long it'll last, but some double sided tape and some other kind of plastic tape I found laying around... Maybe others will do the same to prevent wear like this? It does no harm, just looks bad..

I would have used the soft side of velcro.

gr J

My new one has 11k

So will watch for this. Thanks

Hi my rear ones were the same till I stuck some sticky back black felt to them..

Phils panda said:

Hi my rear ones were the same till I stuck some sticky back black felt to them..

Click to expand...

I have that on the front ones, is that from factory or did someone add that?

I had that on the front as well overtime and the constant warm temp in the summer they peel off so I applied the same stuff to the front as well.More sticky than the OEM stuff

SB1500 said:

I have that on the front ones, is that from factory or did someone add that?

Click to expand...

I guess the factory as all three of my post-2012 Pandas have had what looks like Velcro loop on the front buckles

Phils panda said:

Hi my rear ones were the same till I stuck some sticky back black felt to them..

Click to expand...

Bravo buckles have felt stuff on as standard.