Hi,

I cannot find any thread that can help me.
So I fitted a Panda Mk3 with front fog lights, plug them, bought the new switch panel with the appropriate buttons, I need to reprogramme the ECU for sure but do anyone knows if all the wiring is there or just the terminals for pluging the lights?

A wiring diagram would be much appriciated if anyone has one, I have the VIN number of both cars (with and without foglihts, so PM me if needed)

Thanks

I think the bodycomputer controls this and has to know if frontfogs are installed not the ECU.
Did you check if the fuses are installed?

And... Dobro Jutro!

gr J

As A3jeroen said, being able to control the CANBUS signal switching for the lights requires that the body computer have fog lights listed under the possible signals. You might be able to enable the signalling option through MultiECUScan, but it might also simply not be coded into models without fog lights. A direct 12v circuit with a relay to the dash button might make more sense from a practical aspect.

Did you have any luck on getting the foglichts working?